Switch mode lead acid chargers are designed to effectively charge sealed lead acid batteries while protecting the batteries from over-charging. All charger ratings are based on a nominal in put of 110-120 VAC/ 50-60Hz. The output current ranges from 2.5 Amps to 10 Amps

Features

• Medical approved (EN60601)
• 3 step charge control with timer
• Switch mode charger
• Available in 12V, 24V, 36V and 48V versions
• LED status indicator
• Protected against reverse polarity and short circuit
• Custom specifications on request
• Waterproof version available

Specification

Input rating: Nominal 110-120VAC/50-60Hz

Nominal voltage rating: 12V

Maximum output power: 120 Watts

Input surge current limitation: <30A

Switch frequency: 63 kHz

Leakage current from battery: 2.5 mA (12V battery voltage)

Temperature range: -25°C to +40°C

Ripple: <100mVp-p

Efficiency (at 100% load): 83%

Current limit: yes

Insulation voltage: Primary-ground: 1250VAC, Primary-secondary: 3750VAC, Secondary-ground: 500VAC

Insulation class: Class I

Electrical safety: EN 60601-1, EN 60335-2-29

EMC Standards: EN 60601-1-2 (Medical), EN 61000-6-3(Emission), EN 61000-6-1, EN 55014 (Immunity)

Timer: 4hr ±30 min. (also available with other values)

Input Connection: Grounded US blades

Output Connection: Battery clips

Dimensions/Weight: 7.25" x 6.75" x 2.13" (184 x 171 x 54mm)/3.3 lbs. (1.5 kg)

Recommended Battery Capacity: 40 - 400Ah

other output connection options available upon request

Functionality:

Once the charger is attached to a sealed lead acid battery and plugged in, the charging process will begin. The charger will subject the lead acid battery to three steps of charging.

In the first step, the charger will enter into 'boost' mode. During this step, the charger is in constant current mode with the current rate remaining at its maximum value (note- the battery voltage is lower than the switching level of the timer).

In step two, the battery will be nominally 80-95% charged, and the charger will switch into time controlled/ constant voltage mode (current is no longer being provided at its maximum rate). The charger will continue to provide a constant voltage until the time interval is completed.

The third and final step will place the charger in float/standby mode as the battery will be fully charged. Because the charge voltage is at a standby level, the charger can continue to be connected to the battery. Should the battery be used, the charger can return to rapid charging (step 1). 

Note: The Prices include CORDSETS and adapters. Please call / specify the country this will be used in for us to send an appropriate cord. If no country is specified, we assume that it is for North America.

Battery Attributes
Amp H	10
Voltage	24.0 V

(Please mention the voltage and Amp Hour ( Ah) rating and or the watt hour (Wh) rating of the battery pack the charger will be used for while you place your order)

Minimum Purchase Quantity = 10
Orders placed in Quantity less than 10 will not be processed.