• Pop-up emitter cover consists of a spring-loaded cap and wide flange to prevents turf overgrowth
  
• Engineered crossbar design underneath helps maximize flow while flushing out debris
  
• Molded-in crossbar geometry along with internal ribs provide exceptional durability; supports pedestrian traffic including lawn tractors when properly installed
  
• Available in a variety of sizes and configurations: 3 in., 4 in., 3 in. & 4 in., 6 in., with adapter, with elbow
  
• Use with an elbow and weephole to drain residual water and help prevent stagnation and potential freezing of residual water

Applications

• Install the pop-up drainage emitter at the lowest point in the drainage system
• Place in areas away from buildings and landscapes, away from the curb
• Works with a complete drainage system to release collected stormwater runoff and standing water to a discharge point before it causes costly property damage

Installation & Maintenance

• Position pop-up emitter cover at or below ground level
  
• Extend the lifespan with routine inspections; a clogged pop-up emitter can potentially back up the entire drainage system
  
• Cut and remove turf mat away from the base flange
  
• Clear debris from cover and cap; check drain pipe underneath and remove debris

Materials & Sustainability

• Cap and cover made of high-density polyethylene (HDPE); adapter made of HDPE
• Elbow made of polyvinyl chloride (PVC)
• Pop-up emitters are made in the USA